Ezo Spruce, day one...

Forsoothe!

Imperial Masterpiece
Messages
6,878
Reaction score
9,248
Location
Michigan
USDA Zone
6b
These are like gold-plated hen's teeth, just not generally available locally. I found these two online at Gee Farms, Stockbridge, MI, about 100 miles from my home for $30 each. The lady said they were grafted at 8 years old. My plan is ground- layering now and separating in spring of '23...
Ezo1 2.JPGEzo1 3.JPGEzo1 4.JPGEzo1 6.JPG
Ezo1 8.JPGEzo1 10.JPGEzo1 11.JPGEzo1 14.JPG
 
Last edited:

Forsoothe!

Imperial Masterpiece
Messages
6,878
Reaction score
9,248
Location
Michigan
USDA Zone
6b
And here's number 2...
Ezo2 1.JPGEzo2 2.JPGEzo2 3.JPGEzo2 4.JPGEzo2 5.JPGEzo2 7.JPGEzo2 8.JPGBoth have Milorganite 6-4-0 ferts, Leonardite humate, Kelp meal, and bone char broadcast on the soil and covered with pea gravel to stabilize the soil surface.
 

just.wing.it

Deadwood Head
Messages
12,141
Reaction score
17,546
Location
Just South of the Mason Dixon
USDA Zone
6B
Hmm. I suppose you know what you're doing, but I have to ask....
Starting ground layers at this time of year? Is that a good idea?

Also, what's up with the plastic below the layer?

How will you over-winter them?

I think if I did that, those suckers would be dead in a jiffy.
 

penumbra

Imperial Masterpiece
Messages
9,377
Reaction score
15,841
Location
Front Royal, VA
USDA Zone
6
Hmm. I suppose you know what you're doing, but I have to ask....
Starting ground layers at this time of year? Is that a good idea?
I'm not sure about that. Being conifers I think they will do fine. I might give them some wind protection but that is about all.
I probably would not do an air layer now.
 

Forsoothe!

Imperial Masterpiece
Messages
6,878
Reaction score
9,248
Location
Michigan
USDA Zone
6b
I just checked two JWP that I did the same thing (almost) to in fall of 2018. One bridged and I had to redo it, and the other was a success and I cut the bottom of the rootball off and potted it up until next spring when I will further reduce the roots to just the layered roots. The plastic wrap is wired on these two, not tightly, just above the bottom cambium cut so it can't bridge. There was only a short stretch of trunk available to skin, and I had to remove the lowest rank of branches anyway to have a decent span of bare trunk. The roots are still free to grow in every direction. I will sink the pots for 2 winters and one summer and check them in spring 2023.
 
Messages
337
Reaction score
1,023
Location
Tokyo Japan
USDA Zone
9b
I've never seen anyone layer an ezo before, but supposedly they are one of the easiest conifers for cuttings, so I would imagine layer success rate would also be high.
 

Forsoothe!

Imperial Masterpiece
Messages
6,878
Reaction score
9,248
Location
Michigan
USDA Zone
6b
I did some cuttings, too, such as they are. I figured I had nothing to lose and since they're so hard to some by, the successful ones would be easy to get rid of. I'm also trying to fine-tune the process so I can do it when I really want to. I do figs all the time, but they don't really count. All I had to work with was the twigs I cut off to gain some length of trunk to layer. Be amazed...
ezo 0.JPGezo a.JPG
ezo b.JPG
ezo c.JPG
These will be sunk over winter and shaded with a board so there will be light, but no direct rays.
 
Last edited:

Djtommy

Omono
Messages
1,551
Reaction score
5,367
Location
Tokyo
I doubt this is going to work actually.
while I know it’s possible to air layer ezo spruce, it generally takes a long time And it’s not very reliable.
you say you will separate in 2023. Perhaps by 2023 it has Grown roots however, here there is no longer foliage available to support the existing roots.

when you do a layer that requires a long time I think you need branches below the layer that can support the existing roots. Otherwise those won’t survive for 2 years.
 
Messages
337
Reaction score
1,023
Location
Tokyo Japan
USDA Zone
9b
I doubt this is going to work actually.
while I know it’s possible to air layer ezo spruce, it generally takes a long time And it’s not very reliable.
you say you will separate in 2023. Perhaps by 2023 it has Grown roots however, here there is no longer foliage available to support the existing roots.

when you do a layer that requires a long time I think you need branches below the layer that can support the existing roots. Otherwise those won’t survive for 2 years.
That's an interesting point.

I guess the exception would be if there are other trunks/branches not being layered that are still being supported by the rootstock?
I currently have two layers in progress on a home center shishigashira that's grafted. They're actually stacked on the same trunk right above the graft union. However, there are two other shishi trunks (stalks) still being supported by the rootstock. All of the trunks have continued to grow throughout the season.
Both the air layers are filling up with roots, although I will admit, the top one with way more foliage is filling up quicker.
I've posted a pic to illustrate what I'm doing.
I guess the big difference is maples take very quickly. I'm planning on removing these ones sometimes after they go into dormancy. The top one for sure.

Anyway, I hope it works out for you OP. At the very worst maybe you'll get some rooted cuttings out of it.
 

Attachments

  • 2021 4 17.jpg
    2021 4 17.jpg
    165.5 KB · Views: 14

Forsoothe!

Imperial Masterpiece
Messages
6,878
Reaction score
9,248
Location
Michigan
USDA Zone
6b
These are useless to me as-is. I'm assuming that the new roots provide for the canopy by some amount, perhaps less than less than the reduction in services than the roots that are diminishing on the root stock below, but maybe not. Just how long the lower roots can stay useful in the process is unknown to me, but I have to fight the war as it is, not as I want it. If I had my druthers, I would buy one un-grafted 12" tree, but they don't exist.
 

penumbra

Imperial Masterpiece
Messages
9,377
Reaction score
15,841
Location
Front Royal, VA
USDA Zone
6
These are useless to me as-is. I'm assuming that the new roots provide for the canopy by some amount, perhaps less than less than the reduction in services than the roots that are diminishing on the root stock below, but maybe not. Just how long the lower roots can stay useful in the process is unknown to me, but I have to fight the war as it is, not as I want it. If I had my druthers, I would buy one un-grafted 12" tree, but they don't exist.
Again, I am pulling for you long shot or not. Best of luck.
 

rockm

Spuds Moyogi
Messages
14,182
Reaction score
22,179
Location
Fairfax Va.
USDA Zone
7
Hope you're successful. FWIW, Ezo spruce isn't as rare in the U.S. as some think. .A quick search (Some are wholesale nurseries..):

You can find them if you scrounge around.
 

JeffS73

Shohin
Messages
418
Reaction score
782
Location
South Yorkshire, UK
USDA Zone
8b
Where you say ezo spruce, which one do you mean, picea jezoensis or picea glehnii? Looks more like glehnii compared to my (very few) examples. I thought most of the Japanese yamadori where glehnii, but jezoensis has lovely foliage.
 
Messages
491
Reaction score
731
Location
SW Washington State
USDA Zone
8b
Where you say ezo spruce, which one do you mean, picea jezoensis or picea glehnii? Looks more like glehnii compared to my (very few) examples. I thought most of the Japanese yamadori where glehnii, but jezoensis has lovely foliage.
Tags say jezoensis, I too was under the impression that the "good ones" were glenii
 

Adair M

Pinus Envy
Messages
14,402
Reaction score
34,873
Location
NEGeorgia
USDA Zone
7a
Any updates on this experiment? Are they still alive?

By the way, “Ezo Spruce“is Picea glenii, which has a smaller, more delicate needle, and grows slower. Jezo or Yezo are coarser. Kinda like how San Jose juniper and Procumbens Nana juniper have similar foliage, but San Jose is coarser.
 

Hartinez

Masterpiece
Messages
4,149
Reaction score
13,009
Location
Albuquerque, NM
USDA Zone
7
Any updates on this experiment? Are they still alive?

By the way, “Ezo Spruce“is Picea glenii, which has a smaller, more delicate needle, and grows slower. Jezo or Yezo are coarser. Kinda like how San Jose juniper and Procumbens Nana juniper have similar foliage, but San Jose is coarser.
Forsoothe has been MIA for some time now. 🤷🏼‍♂️
 

sorce

Nonsense Rascal
Messages
32,908
Reaction score
45,579
Location
Berwyn, Il
USDA Zone
6.2
I was hoping he updated this .

Sorce
 
  • Like
Reactions: Ugo
Top Bottom