Recent content by nabil

I didnt know that full sun with 40c heat will crisp the foilage and kill it. Hope it will recover after two lowest branches almost dried up

I bought water repellent anti fungal clear solution for exterior wood. Water based. Hope it will work. And for the lower part (under soil) I will use the thinner with polystyrene as advised. Thanks and wish me luck I will post pictures once I finish

this means you guys have no constraints on what type of wood preservative i might use could cause any poisoning to the soil and the tree trunk!!

Dont think so What type of fungicide can use other than lime sulfur??

Ok right fungicide not preservative

Dears Am planing juniper tanuki. I got the thick dead branch and I want to prepare to apply preservative on it to prevent fungus. No way for me to get lime sulfur. What other chemical preservative can be used? Will copper sulfate work? I have access also to micronized sulfur liquid and...

Dears Am planing juniper tanuki. I got the thick dead branch and I want to prepare to apply preservative on it to prevent fungus. No way for me to get lime sulfur. What other chemical preservative can be used? Will copper sulfate work? I have access also to micronized sulfur liquid...

by the way i am starting Olive Tanuki , i managed to get very interesting pieces of dead oilve wood, very old. and i got some olives cutting rooted two years old. i will work on this project, and i will start new thread and keep you updated.

1- what's the idea of planting up-side-down olive cutting? 2- this sand as much as you water it it stays damp, and all water runs through, it is compacted once dried, but once you water it, it is light again 3- lava rocks i have is crushed average pea size

Pruning Junipers http://www.bonsaiprimer.com/pruning/conifer/conifer.html

What do u mean by where ? It is already layered with this small pot

But based of what I've read. That reb cultivar not root well. So cutting is useless?

questions 1- will maple bud back on trunk chop? 2- what kind of acer are those trees? Are they Japanese maple? Am planning to airlayer thr green branch and keep the red. As it is not natural to have two species on same tree. Are they easy to work with? And bud back? What about root...

the second tree The second tree has bigger trunk more expensive and also grafted.

Today went to nursery. Found two Acers This is the first tree Two varieties one with original one branch (green) and the main is grafted (red) What kind of acer is this? Is it going to be good for bonsai?