Looks like you have a long sacrifice branch (trunk) going, good, just let that keep growing.
Down below, I see you've wired the lower trunk. But it's still pretty straight. What are you trying to achieve? A straight trunk? Or a curved one?
That aluminum, even doubled, isn't really going to be strong enough to do much. Get a starter set of copper from Julian Adams. You'll need 6 gauge copper to really bend that trunk.
In fact if you look at the lowest branch you see it's on the back side of the bend trees going right drawing bad.
When I wired I was thinking of running that as the new apex eventually. But that would take another few years it I use that as first branch I think it's in a good position for where the 2 baby buds popped this spring if they servive.