Cadillactaste
Neagari Gal
It's the same pipe. You can bend it as you wish. I cut off the rectangular section...and bent as I seen fit and then, cut remainder off.Yes, I asked about the length.
In fact, I was asking about the pipe on your post #71. I thought that it was the "device" you would be using.
I realize now that it was not and you are going to use the pipe in the photo above. Am I correct?
Project #2 (larger of the two)
9" tall 10" wide...tilted to allow water to drain for now. (Turned so you could see the shape...this is why it's worth the risk.)