Need advice for broom style

Cajunrider

Imperial Masterpiece
Messages
6,542
Reaction score
12,898
Location
Louisiana
USDA Zone
9A
I would like to develop this Cataegus aestivalis to a broom style.
283E64D7-A386-4CEC-A3D4-8A80EEC46C1C.jpeg

At the chop now I have 5 branches at twi spots. One spot has 2 and the other have 3.
8F593E4D-BC0E-4B21-A406-18A5534535E4.jpeg
1B1E4DEA-67F3-4829-B3DD-A320FDC8C3C2.jpeg

I also have 3 more branches below the chop at 1/2”, 3/4”. and 1”.

I drilled a hole at the chop and carved it out.
B64A1AEC-86A6-4A08-9291-69B34037C893.jpeg
A85A0B17-3941-4010-AC10-E76BD3733728.jpeg

Suggestions on progression plan are appreciated.
 
Messages
387
Reaction score
680
Location
Idaho
USDA Zone
7-8
I would just let it run. I’d suggest thinning the area where a few branches originate from the same location.
 

Hartinez

Masterpiece
Messages
4,149
Reaction score
13,015
Location
Albuquerque, NM
USDA Zone
7


2 of the better threads on here that detail the best process.
 

Firstflush

Chumono
Messages
982
Reaction score
1,135
Location
NW Montucky
USDA Zone
3-4
Like above, remove extras starting at one location. Maybe at the twofer you can wire one out to the side. Watch for swelling at the top cut.
 

Adair M

Pinus Envy
Messages
14,402
Reaction score
34,874
Location
NEGeorgia
USDA Zone
7a
Here are a couple of photos of Mr Ebihara’s “Million Dollar Zelkova” under development:

052FD9A0-DAE2-438E-9FD9-8750319E3DBC.jpeg

7619FE47-0065-4FB8-8EB7-5749DCED7393.jpeg

The photos go from right to left.
 

Adair M

Pinus Envy
Messages
14,402
Reaction score
34,874
Location
NEGeorgia
USDA Zone
7a
is that your zelcova?
No, that is Mr. Ebihara’s zelkova. He developed it by cutting back a trunk, drilling out the core, letting new shoots pop out, taking V cuts between the shoots, grafting on branches as needed. As you can see in the pictures, he started this project around 1976. I don’t know exactly when he decided to show it, but when he did, everyone was astonished. The story goes that he was a virtual unknown before this, practicing his skills in his back yard. Some people went to his place, and offered him “a Million Dollars” for his zelkova. ( this was sometime in the mid 1990’s I believe.). He turned them down. They were insulted he refused their offer. But, he wanted to continue to improve the tree!

My tree is older. Most likely started from seed in the 1910’s to 1920’s. And it’s not as big around. My tree was shown at Kokofu in 1954. Mr. Ebihara started his project around 1974. I don’t know how old the trunk was when he started the project.
 

Adair M

Pinus Envy
Messages
14,402
Reaction score
34,874
Location
NEGeorgia
USDA Zone
7a
My point in showing Mr Ebihara’s tree is how to create structure: you let the branches grow out, develop a bit of girth, then cut back HARD. Repeat. And repeat it again, and again. This process develops taper in those structural branches. You do NOT go for ramification immediately. You must first build structure. Once you have structure, THEN begin ramification.

WP’s method may build ramification, but it does not build good structure. Quite frankly, ramification is easy… it’s the STRUCTURE that’s hard to build. Well, it’s not actually hard… it just takes time. And here’s the thing… WP buys good brooms from Japan that already have good structure, then uses hedging to get ramification. What we mere mortals need to learn to do is learn to build STRUCTURE! And the two photos I posted up above show you how it’s done.
 
Top Bottom