just.wing.it
Deadwood Head
Here's what I do.... 2.5mm aluminum.
How Do You Wire Your Tree Into a Pot with One Drainage Hole?
- Thread starter just.wing.it
- Start date
Check out this post: https://bonsaitonight.com/2016/12/27/secure-bonsai-pot/
Wires_Guy_wires
Imperial Masterpiece
I would do it like this.
Thus is how I do it. It’s ver similar to wire-guy-wire’s method:
I make a contraction of a heavier wire and wrap two thinner wires around it like so:
insert it thru the bottom if the pot:
What you get inside:
This pot had wire holes so, the contraption wasn’t needed, but I did it for illustration.
I make a contraction of a heavier wire and wrap two thinner wires around it like so:
insert it thru the bottom if the pot:
What you get inside:
This pot had wire holes so, the contraption wasn’t needed, but I did it for illustration.
Lazylightningny
Masterpiece
Some great ideas here
just.wing.it
Deadwood Head
I have done this before too! Probably a better way.
Very nice!
Thanks for sharing guys!
just.wing.it
Deadwood Head
I knew I did that method before....on my azalea....last spring.
Hartinez
Masterpiece
Yeah I’ve used the same technique as Adair uses. Works well.
I make the cotter pine with thicker gauge wire like the above posts. Very simple and very effective. If you tighten and the pin starts to give, use copper or a higher mm of aluminum. My 2 cents.
cheap_walmart_art
Omono
This is the one I follow.
penumbra
Imperial Masterpiece
Yeah, that is the traditional method but the op was talking about needing the wires off center. I have purchased pots that were already wired the way you have shown and it is effective.
