PiñonJ
Omono
I ordered a hydraulic chair base to make my own turntable. Saved over $100 compared to what’s available on the market.
The top bracket is designed for a chair that reclines slightly, so it’s not level. Had to come Up with a way to level the tabletop.
I used these composite shims:
The excess just snaps off.
Countersunk bolts:
The (almost) finished product:
I have some EPDM rubber sheeting that I’ll cut to fit the top.
The top bracket is designed for a chair that reclines slightly, so it’s not level. Had to come Up with a way to level the tabletop.
I used these composite shims:
The excess just snaps off.
Countersunk bolts:
The (almost) finished product:
I have some EPDM rubber sheeting that I’ll cut to fit the top.